Eldes ESIM264 Manual de usuario descargar pdf (Pagina 7)

USER MANUAL ELDES ESIM264 V1.0 7

E.g. XXXX_INFO:0.2, means that status message will be sent every 2 hours.

To disable periodic status messages, send SMS:

The status message INFO will not be sent until enabling or restoring default parameters.

2.9 Remote Microphone listening

To be able to listen what is going on in remote house can be done in two dierent ways:

1. When alarm has been activated, the system will ring pre-programmed numbers and user can answer the call. Remote

microphone will be enabled for listening.

2. By sending SMS message

The system will ring the sender of former SMS, and upon answering the call, user can listen to any sounds in the building. The

phone call must be answered within 20 seconds otherwise the system will stop trying and return to previous state.

2.10 Receiving alarm message due to temperature deviation

The system ESIM264 informs the user by SMS message in the case if temperature deviation from the set values. In order to use

this function it is necessary to connect temperature sensor and set the parameters accordingly. Examples of usage: temperature

control for greenhouses, houses, aquariums, server premises, refrigerators etc. over a GSM network.

Manufacturer set this function o. To turn the system on send the following SMS message:

min – temperature in oC, it can have values [-55...+125] max – temperature in

C, can have values [-55...+125].

If the controlled temperature drops below min value by one degree, the user will receive SMS message with the temperature at

that time. If the controlled temperature rises above max value by one degree, the user will receive SMS message with the tempe-

rature at that time.

E.g. XXXX_TEMP:16:20 means that SMS message will be sent if the temperature drops below 16

C or rises above 20

XXXX_TEMP:-10:-1 means that SMS message will be sent if the temperature drops bellows -10

C or rises above -1

To see temperature settings send the following SMS message:

To turn o temperature control, send the following SMS message:

If the value received by the system is two zeros, it will not react to temperature change. However, if the

sensor is connected, temperature information will be sent together with INFO message, as described

in section 2.8.

XXXX_INFO:00.00

XXXX_TEMP:min:max

XXXX_TEMP

XXXX_TEMP:0:0

1111 M:

OFF

1111 INFO

:0.2

XXXX_MIC

ESIM 264

1111 TEMP

:16:20

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Sin comentarios

Eldes ESIM264 Manual de usuario Pagina 7