Eldes ESIM264 Manual de instalación descargar pdf (Pagina 24)

EKB3

The system conguration and control with EKB3 keyboard is performed by activating the Conguration Mode using the

administrator password (the default administrator password is 1470) and entering a valid conguration command using

the number keys (0... 9) and [#] key for conrmation. The indication of each pressed key is provided by zone red LEDs

when entering a conguration command. The structure of standard conguration command is a combination of digits.

EKB3 conguration command and valid parameter value range are indicated in brackets.

EKB3 indications which are relevant during Conguration Mode are described in the table below.

Indication Description

Red LED ARMED ashing Conguration mode activated successfully.

Yellow LED SYSTEM ashing Valid parameter is entered and waiting for value.

1 Long Beep Non-existing command or parameter value entered.

3 Short Beeps Command entered successfully.

NOTE: The system can be congured using one keyboard at a time only. Other connected keyboards become inactive in Con-

guration Mode.

Software ELDES Conguration Tool is intended to work directly with ESIM264 alarm system, which can be connected to

the computer via USB port or via GPRS connection remotely. This software simplies system conguration process by al-

lowing to use a personal computer in the process. Before starting to use ELDES Conguration Tool, please, read user guide

available in the software’s HELP section.

ELDES Conguration Tool is freeware and can be downloaded from ELDES website at: www.eldes.lt

This command activates and deactivates the Conguration Mode.

Conguration

Mode

Enter administrator password:

[*aaaa#]

Value: aaaa – 4-digit adiministrator password.

CONFIGU

RATION

TOOL

EKB3

5.3.1 Establishing Remote Connection Between ESIM264 System and Conguration Server

5.3 Remote System Conguration via GPRS Connection

Before conguring ESIM264 remotely via GPRS connection, make sure that:

• SIM card is inserted into ESIM264 device.

• Mobile internet service is enabled on the SIM card.

• Power supply is connected to ESIM264.

• Default SMS password is changed to a new 4-digit password;

• At least User1 phone number is set up.

ATTENTION! The system will NOT send any data to monitoring station while conguring the system remotely via GPRS network.

However, during the conguration session, the data messages are queued up and transmitted to the monitoring station after the

conguration session is over.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 139 140

Sin comentarios

Eldes ESIM264 Manual de instalación Pagina 24