Eldes EKB3 Manual de instalación descargar pdf (Pagina 110)

110

110 EN

MANUAL ELDES ESIM264 V3.1

Jumper position Address Jumper position Address

Keypad 1

Keypad 3

Keypad 2

Keypad 4

The address of each connected keypad is also indicated in ELDES Conguration Tool software.

31.1.1.2. Installation

1. Remove the screw located on the bottom side of the enclosure (see Fig. No.

40)

2. Detach keypad holder from EKB2 keypad by gently pulling the holder

towards yourself (see Fig. No. 41).

3. Fix the keypad holder on the wall using the screws. (see Fig. No. 42)

4. Disconnect ESIM264 main power supply and backup battery.

5. Wire up keypad terminals to ESIM264 alarm system respectively – Vin to

AUX+, COM to AUX-, Y to Y, G to G (see Fig. No. 43).

6. Connect a sensor and the resistor across Z1 and COM terminalss in accor-

dance with zone connection Type 1 or Type 2 (see 2.3.2. Zone Connec-

tion Types). As keypad zone Z1 is disabled by default, it can be enabled

by SMS, ELDES Conguration Tool, EKB2 and EKB3 keypad. Keypad zone Z1

must be enabled and resistor connected even if the tamper button alone is

required (see Fig. No. 43).

NOTE: Keypad zone connection type can dier from selected on-board

zone connection type.

NOTE: ATZ mode is NOT supported by keypad zones. ATZ mode is

ineective for keypad zones when enabled.

7. Set the keypad address by putting the jumper on A0 and A1 pins (see

32.1.1.1.4 Keypad Address).

8. Fix the keypad into the holder.

ATTENTION: Before xing the keypad into the holder please , make

sure that the tamper button is properly pressed (see Fig. No. 39).

9. Screw in the bottom side of the enclosure. (see Fig. No. 40).

10. Power up ESIM264 alarm system.

11. EKB2 keypad is ready.

For more details on multiple keypad wiring, please refer to 3.2.7. RS485

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 167 168

Sin comentarios

Eldes EKB3 Manual de instalación Pagina 110