
17
17EN
MANUAL ELDES ESIM264 V3.1
2.3.4. iButton Key Reader and Buzzer
BUZ-
BUZ+
+-
DATA
COM
BUZZER
iButton
key reader
10
Supported iButton key model: Maxim/Dallas
DS1990A
The iButton key reader can be installed with buzzer
or separately. The buzzer is intended for audio in-
dication of exit/entry delay countdown providing
short beeps.
1 Connect iButton key reader terminal wires to
1-Wire interface: COM and DATA terminals res-
pectively.
2 Connect buzzer‘s negative terminal wire to BUZ-
and positive terminal wire to BUZ+.
3 Additionally, a LED indicator for visual indication
can be installed in parallel to buzzer or instead.
Connect LED anode terminal to BUZ- and catho-
de to BUZ+.
NOTE: The installation of buzzer is not necessary if EKB2/EKB3 keypad is used.
ATENTION: The cable length for connection to 1-Wire interface can be up to 30 meters max.
2.3.5. Temperature Sensor and iButton Key Reader
Supported iButton key model: Maxim/Dallas DS1990A
Supported temperature sensor model: Maxim/Dallas DS18S20, DS18B20
COM
DATA
+5V
COM
DATA
+5V
GND +5V
DATA
TEMPERATURE SENSOR
DS18S20, DS18B20
GND
DATA
+5V
iButton
key reader
DS1990A
TEMPERATURE
SENSOR
DS18S20,
DS18B20
GND DATA +5V
11
1 Connect temperature sensor GND, DATA, +5V
terminals to 1-Wire interface: COM, DATA and
+5V terminals respectively.
2 When connecting iButton key reader in parallel
to temperature sensor, connect iButton key rea-
der terminal wires to COM and DATA terminals
respectively.
ATENTION: The cable length for connection to
1-Wire interface can be up to 30 meters max.
2.3.6. Relay Finder 40.61.9.12 with Terminal Socket 95.85.3 to PGM Output
LED
A1
C1
AUX+
A2
COIL
RELAY
12
1 Wire up relay A1 terminal to PGM output Cx and
A2 terminal to AUX+.
2 In addition, connect LED indicator‘s anode ter-
minal to relay A2 terminal and cathode to A1
terminal.
Comentarios a estos manuales