
133
133EN
MANUAL ELDES ESIM264 V3.1
NOTE: The battery status can be monitored in real-time using ELDES Conguration Tool software.
NOTE: The system sends an SMS message to a preset User 1 as soon as the battery level runs below 5%.
32.4.5. Restoring Default Parameters
1. Remove the battery from EWD1.
2. Press and hold the RESET button.
3. Insert the battery back to EWD1.
4. Hold the RESET button until LED indicator provides several short ashes.
5. Release the RESET button.
6. Parameters restored to default.
32.5. EWK1 - Wireless Keyfob
Main EWK1 features:
• Alarm system arming & disarming;
• Panic button;
• PGM output control;
• Sound indication by built-in mini buzzer.
Keyfob EWK1 – is a wireless device intended to arm and disarm ESIM264 alarm system, to open and close the gates or to control any other de-
vice connected to the alarm system. Wireless keyfob EWK1 is compatible with ELDES wireless alarm systems, therefore user can easily bind it to
the alarm system using ELDES Conguration Tool software or sending a corresponding SMS command. EWK1 keyfob features four congurable
buttons intended to operate according to individual needs. After the button is pressed, EWK1 internal buzzer’s sound signal conrms a trans-
ferred command to ESIM264 alarm system via wireless connection. The status of the sent command can be checked by attempting to receive
the feedback signal from the alarm system. This can be performed by pressing down the same button and holding it for 3 seconds. 3 short sound
signals indicate a successfully carried out command while 1 long beep stands for failed command and feedback signal failure. By default one pair
of buttons is already congured to arm and disarm the alarm system.
65
The virtual zones of ESIM264 system are intended for EWK1 button cong-
uration. Please, refer to software’s ELDES Con guration Tool HELP section
for more details.
It is possible to connect up to 5 EWK1 devices to ESIM264 alarm system at
a time. The maximum wireless connection range is 150 meters (in open
areas).
NOTE: Fig. No. 65 reects the default EWK1 button conguration. All keyfob buttons are congurable according to individual needs.
32.5.1. Technical Specications
32.5.1.1. Electrical & Mechanical Characteristics
Battery Type CR2032 Lithium
Battery Voltage; Capacity 3V; 240 mAh
Quantity of Batteries 1
Battery Operation Time ~18 months*
Wireless Transmitter-Receiver Frequency 868 Mhz
Range of Operating Temperatures -20...+55ºC
Wireless Keyfob Dimensions 54 x 42 x 13 mm
Humidity
0-90% RH @ 0... +40 °C (non-condensing)
Wireless Communication Range Up to 30 meters in premises; up to 150 meters in open areas
Compatible with Alarm Systems ELDES Wireless
* The operation time depends on dierent conditions and may vary.
Optional
functionality
Optional
functionality
Arm the
system
Disarm the
system
Comentarios a estos manuales