Eldes EKB3 Manual de instalación descargar pdf (Pagina 134)

134

134 EN

MANUAL ELDES ESIM264 V3.1

32.5.2. Installation

1. Unscrew the EWK1 keyfob housing. 2. Open EWK1 keyfob housing.

3. Insert CR2032 battery provided in the EWK1 package.

Before inserting the battery, make sure that the battery’s “+” sign is facing the outer side.

CR2032

4. Close and screw up the keyfob housing.

5. Bind the device to the alarm system by sending a corresponding command via SMS text message or using ELDES Conguration Tool soft-

ware. Please, refer to the software‘s HELP section or refer to 19.1. Binding, Removing and Replacing Wireless Devices for more

details.

6. While binding the device to the alarm system, press any EWK1 button several times.

7. EWK1 is ready to use.

NOTE: If you are unable to bind the wireless device please , restore the parameters of the wireless device to default and try again. See

32.5.5. Restoring Default Parameters for more details.

32.5.3. EWK1 Zones (Panic Button)

EWK1 keyfob supports a Panic Button feature allowing to cause alarm at any time when the specied button is pressed. This feature can be

congured using ELDES Conguration Tool software by creating a virtual zone of Panic/Silent or 24-Hour type and assigning it to Virtual Alarm

option. The Panic Button feature can be set up on any button of EWK1. For more details, please refer to software’s HELP section.

32.5.4. Battery Replacement

1. Open EWD1 enclosure.

2. Remove the old battery from the battery slot.

3. Postition the new battery according to the appropriate battery slot positive terminal indicated.

4. Insert the battery into the battery slot.

5. Battery replaced.

For more details, please refer to 32.5.2 Installation.

ATTENTION: Only CR2032 3V batteries can be used. Install only new, high quality and unexpired batteries. Do not mix the old batteries

with the new ones.

ATTENTION: At least 1 battery must be removed if the device is not in use.

ATTENTION: In order to avoid re or explosion hazards, the system must be used only with approved battery. Special care must be

taken when connecting positive and negative battery terminals. Dispose old batteries only into special collection sites. Do not charge,

disassemble, heat or incinerate old batteries.

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 167 168

Sin comentarios

Eldes EKB3 Manual de instalación Pagina 134