Eldes EKB3 Manual de instalación descargar pdf (Pagina 146)

146

146 EN

MANUAL ELDES ESIM264 V3.1

32.9.3. Installation

1. Detach the mounting plate by turning it counter-clockwise from

the back of EWF1 (see Fig. No. 88).

2. Secure the mounting plate to ceiling or wall with mounting

screws.(see Fig. No. 88).

3. Lift to open the battery pocket door (see Fig. No. 88).

4. Insert the battery into the battery pocket considering the po-

larity terminals indicated on the enclosure of EWF1. Ensure the

battery is securely connected. Red LED may ash briey when

the battery is being installed.

5. Close the battery pocket door by snapping it into place.

6. Position the smoke detector to the mounting plate by turning

it clockwise to lock into place. Note that the device will not lock

into the mounting plate without the battery being present in

the battery pocket.

7. 7. Push the TEST button to verify if the wirless smoke detector is

operational. See 32.9.5.1. Testing EWF1.

8. Bind the device to the alarm system by sending a corresponding

command via SMS text message or using ELDES Conguration

Tool software. Please, refer to the software‘s HELP section or

refer to 19.1. Binding, Removing and Replacing Wireless

Devices for more details.

6. The system automatically informs about successful/unsuccess-

ful binding process. If attempt to bind is unsuccessful, try to

move EWF1 closer to alarm system device and bind it again.

10. EWF1 wireless smoke detector is ready for use.

Mounting slot

Screws

Battery pocket door

Mounting plate

NOTE: If you are unable to bind the wireless device, please restore the parameters of the wireless device to default and try again. See chap-

ter 32.9.6. Restoring Default Parameters for more details.

32.9.4. Interconnection

The interconnection feature automatically links all wireless smoke detectors resulting in causing an instant alarm in the system along

with the rest of EWF1 wireless smoke detectors. For more details on interconnection feature and how to manage it, please refer to 20.4.

EWF1 Interconnection.

32.9.5. Maintenance

32.9.5.1. Testing EWF1

• The TEST button veries if EWF1 is operational. Firmly push the TEST button and the wireless smoke detector will sound a loud beep.

The alarm will stop sounding after releasing the TEST button. When testing EWF1 using ELDES Conguration Tool software, the

detector will provide short beeps.

• Stand at arm’s length from the wireless smoke detector when testing.

• Test wireless smoke detectors weekly and upon returning from vacation or when no one has been in the household for several days.

• Test each wireless smoke detector to be sure it is installed correctly and operating properly.

• DO NOT use an open ame to test this wireless smoke detector. You may ignite and dam age the wireless smoke detector or your

home.

• If the wireless smoke detector does not sound, please check the battery and signal level using ELDES Conguration Tool software.

ATTENTION: Test all wireless smoke detectors weekly to ensure proper operation.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 167 168

Comentarios a estos manuales

Sin comentarios

Eldes EKB3 Manual de instalación Pagina 146

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Eldes EKB3