Eldes EKB3 Manual de instalación descargar pdf (Pagina 24)

24 EN

MANUAL ELDES ESIM264 V3.1

NOTE: We advise you to choose the same GSM SIM provider for your system as for your mobile phone. This will ensure the fastest,

most reliable SMS text message delivery service and phone call connection.

NOTE: Even though alarm system ESIM264 installation process is not too complicated, we still recommend to perform it by a person

with basic knowledge in electrical engineering and electronics to avoid any system damage.

4. GENERAL OPERATIONAL DESCRIPTION

When the system is being armed, it will initiate the exit delay countdown intended for the user to leave the secured area. During the count-

down period the buzzer will emit short beeps and/or LED indicator will ash. By default, exit delay duration is 15 seconds. After the count-

down is complete, the system will become armed and lock the conguration by keypad possibility. In case the user does not leave the se-

cured area before the countdown is complete, the system will will arm in Stay mode if at least 1 zone has Stay attribute enabled. By default,

if there is at least 1 violated zone or tamper, the user will not be able to arm the system until the violated zone or tamper is restored. In case

it is required to arm the alarm system despite the violated zone presence, the violated zone can be bypassed or Force attribute enabled.

After the system is armed and if a zone (depending on type) or tamper is violated, the system will cause an alarm lasting for 1 minute (by

default), During the alarm, the siren/bell will provide an alarm sound along with the buzzers of the keypads. By default, the system will also

makes a phone call and send an SMS text message containing the violated zone or tamper number to a preset user and indicate the violated

zone or tamper number on the keypad. If another zone or tamper is violated or the same one is restored and violated again during the alarm,

the system will act as mentioned previously, but will not extend the alarm time.

After the user enters the secured area, the system will initiate the entry delay countdown intended for system disarming. During the count-

down period, the buzzer will emit a steady beep and/or LED indicator will light ON. By default, entry delay duration is 15 seconds. After the

user successfully performs the disarming process, the system will unlock the keypads. If the user does not disarm the system in time, the

alarm system will cause an instant alarm.

NOTE: The alarm will be caused even if a tamper is violated while the system is disarmed.

For more details, please refer to 12. ARMING AND DISARMING.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 167 168

Sin comentarios

Eldes EKB3 Manual de instalación Pagina 24